Manufacturer for Flexible Metal Corner Tape - Flexible Metal Corner Tape for Inside and Outside Corner – Ruifiber

Details Of Drywall Corner Tape

Flexible Metal Corner Tape is a combination of Joint Tape and metal strips laminated to form an external or internal corner. It is particularly recommended for inside corners on cathedral ceilings, kneewalls, stairways, or any outside or inside corner less or more than 90 degree.  It is applied with the metal side to the face of the corner and is embedded into the joint compound.

It comes in roll size varying in size from 50mm x 30m, 52mm x 30m, 50mm x 30.5m etc. Other length also available according customers’ requirements.

Introduction Of Drywall Corner Tape

◆ Cutting it with scissors according to corner lenght the actual length of each side

◆ Apply the joint putty on both sides of the corner, fold it according to the center line, paste the metal strip surface into the joint putty (one side of the metal steel strip should be pasted inside), squeeze out the
excess putty, and clean the surface with a plastering knife. During construction, the metal corner tape at the corner shall not overlap, otherwise the flatness will be affected.

◆ After drying, apply a layer of joint putty on the surface. If necessary, use fine sandpaper to gently polish.

Advantages

◆ Fast and easy application

◆ Coveniet for stock, transportation in rolls

◆ Applied for inside and outside corners

◆ Apply by embedding tape into joint compound

◆ Not only for drawall corner but also for cathedral ceilings, stairways etc

Specification Of  Drywall Corner Tape

Packing and Delivery

Each metal corner tape is wrapped up in inner paper box and then packed in a cardboardbox. The carton are stacked horizontally onto pallets,All pallets are stretch wrapped and strapped to maintain stability during transport.