OEM/ODM Factory Scrim Tape Corners - 50mm Metal Flexible Corner Tape Flex For Building Construction – Ruifiber

Detals Of Drywall Corner Tape

Flexible Metal Tape is made with hith quality paper and  two reinforcing strips of metal, galvanized steel or aluminum stripes. It is easy application and provides permanent protection for corners.The Flexible Metal Tape is easier to use than traditional metal corner bead. It is packed in rolls making it easier to merchandise and transport, it also reduce waste and cost., the customers can cut only the size they need.

Introduction Of Flexible Metal Tape

◆ According to the actual length of each side, the Flexible Metal Tape is cut vertically with scissors to meet the construction length requirements.

◆ Apply the joint putty on both sides of the corner, fold it according to the center line of the metal corner tape, paste the metal strip surface into the joint putty (one side of the metal steel strip should be pasted inside), squeeze out the
excess putty, and clean the surface with a plastering knife. During construction, the metal corner tape at the corner shall not overlap, otherwise the flatness will be affected.

◆ After drying, apply a layer of joint putty on the surface. If necessary, use fine sandpaper to gently polish.

Advantages

• high tensile strength
• corrosion resistance
• dimensional stability
• water resistance
• high porosity 
• easy saturation by bitumen and joint compound

Specification Of Flexible Metal Tape

Packing and Delivery

Each Flexible Metal Tape is wrapped up in inner paper box and then packed in a cardboard box. The carton are stacked horizontally onto pallets,All pallets are stretch wrapped and strapped to maintain stability during transport.